The geotextile is placed under the turf, this provides pressure and noise reduction when operating at a stabilized subsoil.
Roll out the geotextile, cut it out to size and attach it with screws on the posts. Little tip: spray the geotextile with water, put it onto the surface and it will not move when you pull the turf about / rolls. After the geotextile cut and placed, one can start rolling out the turf rolls. Choose a fiber direction and hold it for the rest of the project.
The grain is best placed in the direction from which one looks most to the garden. The best effect is obtained when one looks into the fibers (facing you).
Cutting to size and edge finishing of the artificial grass is best done with a sturdy, sharp knife (eg Stanley knife). First cut the edge of the cloth mother. You can focus on the last tuft line.
Moreover, you best cut diagonally along the back, between the loops of the grass fibers. So you do not damage fibers. Provide for cutting to size each a margin of 5cm, this margin can remove you in the end. Put the seams together on 1 mm too far if you see the surface, if too close grass will not lie on the ground ... do this now with all seams.
Under the joint with an adhesive tape placed . as soon as all the cutting is over , and the artificial grass is located in the desired location, the two-component adhesive may be mixed with the aid of a hand blender.
The adhesive is best in smaller portions over molded to facilitate . Distribution in the adhesive tape The distribution of the glue is done with a trowel , also using plastic gloves is recommended . Too much glue will settle through the seams and perforations between the fibers , so it is imperative that any adhesive be removed immediately.
Please note it is true that this glue hardens rapidly and impossible to use in rainy weather ! The seams are then shut down and then pressed firmly . When it closed down , it is convenient to work with two people and make . Artificial turf like a zipper close After the shut down of the seams have to be at least 3 times over the entire length of the seam to be walked.
Do this in small steps in order to stomp . Complete seam
If you follow step by step , you should be able to put in your garden or patio . Turf itself capable of this manual